|
Exhibit 1, 561 FW 9 |
New Date: February 11, 2013 Series: Pollution Control and Environmental Compliance Part 561: Compliance Requirements Originating Office: Division of Engineering |
|||
|
|
The large (6-inch x 6-inch) PCB label is required as described below unless an item is too small (see 40 CFR 761.45). If an item is too small, you may use an identical
small (2-inch x 2-inch) label.
PCB Marking Requirements |
|
Item or Location |
PCB Marking Required |
PCB Container (50 ppm or greater) |
Large PCB label |
PCB Transformer (500 ppm or greater) |
Large PCB label |
PCB Large Capacitor (500 ppm or greater) |
Large PCB label |
PCB Article Container |
Large PCB label |
PCB Transformer enclosures (vault doors, machinery room doors, substation fence, hallway, etc.) |
Large PCB label |
PCB storage for disposal area (temporary and long term) |
Large PCB label |
Transport vehicle loaded with greater than 45 kg (99.4 lbs) of PCB liquids in PCB Containers, or one or more PCB Transformers |
Large PCB label on front, back, and both sides of the trailer. (Note: A DOT Class 9 placard with ID number 2315 also may be required. Check with your disposal company and shipper.) |
Fluorescent light ballasts manufactured between July 1, 1979 and July 1, 1998 |
Manufacturers were required to mark with the statement “No PCBs.” |
For more information about this exhibit, contact the Division of Engineering. For more
information about this Web site, contact Krista Bibb in the Division of Policy and Directives Management.
PDM Web sites: Centralized Library of Servicewide Policies | FWS Forms | PDM Services
Privacy, Disclaimer and Copyright Information | Information Quality Act
U.S. Fish and Wildlife Service Home Page | Department of the Interior | USA.gov | About the U.S. Fish and Wildlife Service | Accessibility | Privacy | Notices | Disclaimer | FOIA